Magnum Energy MM Series Installation And Operation Manual
Magnum Energy MM Series Installation And Operation Manual

Magnum Energy MM Series Installation And Operation Manual

Remote controls for inverters
Hide thumbs Also See for MM Series:

Advertisement

Remote Controls

for MM Series
Inverters
Installation and
Operation Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MM Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Magnum Energy MM Series

  • Page 1: Remote Controls

    Remote Controls for MM Series Inverters Installation and Operation Guide...
  • Page 2 ©2006 Magnum Energy Inc.
  • Page 3: Contact Information

    Restrictions on Use The MM Series Remote Control shall not be used in connection with life support systems, life saving or other medical equipment or devices. Use of this particular equipment is at your own risk.
  • Page 4: Table Of Contents

    List of Contents 1.0 Introduction ................1 Remotes Available ................. 1 Basic Features ................1 2.0 Installation ................2 Mounting ..................3 Flush Mounting ................3 Surface Mounting ..............4 3.0 Operation ................6 Start-up ..................6 Factory Default Settings ..............6 Operation ..................
  • Page 5: Introduction

    1.0 Introduction 1.0 Introduction Congratulations on your purchase! The MM Series remote control from Magnum Energy, Inc. is designed to be simple to install and use, allow easy control and quick indication of the inverter’s (and charger) status. Remotes Available The MM-R and the MM-RC are the two MM remote controls available to use with the MM Series inverter.
  • Page 6: Installation

    Pre-installation • Carefully remove the MM Series remote from its shipping container and inspect all contents. Verify the following items are included: - The correct MM remote panel display (MM-R or MM-RC) - Mounting Ring (used for surface mounting) - 25’...
  • Page 7: Mounting

    2.0 Installation Mounting The remote control panel can be flush mounted thru an opening in a wall; or if there is insufficient room behind the wall or no desire to cut into the wall, the remote can be surface mounted. Caution: Always check for hidden electrical wires, pipes and cables BEFORE drilling or cutting or screwing into walls or cabinets.
  • Page 8: Surface Mounting

    2.0 Installation Surface Mounting The remote control can be mounted on the surface of a wall by using the mounting ring. Note: The mounting ring has a tabs at the top and bottom that are made with a thinner material. This allows these tabs to be cut or broken out to allow the communication cable to be routed up or down the wall.
  • Page 9: Figure 5, Remote Display Dimensions

    2.0 Installation INVERT BULK AC IN ABSORB ON/OFF FAULT FLOAT Side Front Figure 5, Remote Display Dimensions Side Front Figure 6, Mounting Ring Dimensions ©2006 Magnum Energy Inc.
  • Page 10: Operation

    3.0 Operation 3.0 Operation Start-up After Installing and connecting the MM Series remote control, the remote should be tested to ensure it is functional. 1. Press the ON/OFF push-button located on the display panel. Note: The ON/OFF control switch is a push-button switch which functions by momentary pressing and releasing.
  • Page 11: Operation

    MM Series remote controls have an ON/OFF switch that performs same function as the ON/OFF switch on the front of the MM Series inverter. This remote control also has LED indicators to show the current operating mode of the inverter and charger (MM-RC only) and to help troubleshoot you system if you have a fault.
  • Page 12: Monitoring The Led Indicators

    • FAULT - Fault Mode status • BULK, ABSORB or FLOAT (MM-RC only) - Charge Mode status Note: To understand more about the operating modes of the inverter or charger, refer to the MM Series Inverters, Installa- tion and Operation Guide. MM-R and MM-RC Remotes...
  • Page 13 Once you have determined and cleared the fault the inverter can be turned on. To help clear the fault condition, refer to the Troubleshooting section in the MM Series Inverters, Installation and Operation Guide. • Blinks On 1 time every 4 seconds - Low Battery Voltage;...
  • Page 14: Mm-Rc Remote Only

    3.0 Operation MM-RC Remote Only The MM-RC provides three additional charging LED indicators to provide information on the operation of the battery charger. Monitor these indicators for at least 10 seconds to determine the charger status. BULK (yellow) - • On (solid) - Bulk Charging; the charger is delivering maximum current to the batteries.
  • Page 15: Warranty And Service Information

    4.0 Warranty and Service Information 24 Month Limited Warranty Magnum Energy, Inc., warrants the MM Series Inverter to be free from defects in material and workmanship that result in product failure during normal usage, according to the following terms and conditions: 1.
  • Page 16 Magnum Energy, Inc. 1111 80th Street SW - Suite 250 Everett, WA 98203 phone: 425.353.8833 fax: 425.353.8390 web: www.magnumenergy.com PN: 64-00012 ©2006 Magnum Energy Inc.

Table of Contents