Configuration Cables; Introduction; Appearance; Specifications - Raisecom iTN2100 Hardware Description

Raisecom
iTN2100 (P100R002) Hardware Description

21.3 Configuration cables

21.3.1 Introduction

The configuration cable is used to connect the Console interface on the iTN2100 to the PC
that runs terminal emulation program. You can configure the iTN2100 through command
lines.

21.3.2 Appearance

Use the DB-9 connector and RJ45 connector as configuration cable connectors for the
iTN2100, as shown in Figure 21-8.

Figure 21-8 Configuration cable

21.3.3 Specifications

Table 21-4 lists specifications of the configurable cable.

Table 21-4 Specifications of the configurable cable

Name
Connector
Type

21.4 DC power cables

21.4.1 Introduction
The DC power supply cable transmits -48 V or +24 V DC electricity to terminal block of the
rear panel, and supplies power to the whole iTN2100.
Parameter
CBL-RS232-DB9F/RJ45-2m
RJ45 connector, DB9 female connector
Unshielded Category 3 flat cable
Raisecom Technology Co., Ltd.
Description
21 Cables
250