Dip Switches; Table 13-45 Configurations Of The Dip Switch On The Itn2100-Eot-Gestm4 - Raisecom iTN2100 Hardware Description

Raisecom
iTN2100 (P100R002) Hardware Description
ACT
LOF (1–4)
LOS (1–4)

13.9.5 DIP switches

Table 13-45 lists configurations of the DIP switch on the iTN2100-EOT-GESTM4.

Table 13-45 Configurations of the DIP switch on the iTN2100-EOT-GESTM4

SW1
No.
Bit1
Bit2
By default, Bit1 is OFF.
When configuring the SDH interface on the backplane to take effect through Bit2, you
need to set Bit1 to ON.
Interface Status
Green
Red
Red
Function Status
Set the optical
ON
interface rate.
OFF
Set the valid ON
SDH interface.
OFF
Raisecom Technology Co., Ltd.
Description
Primary/Slave LED for the aggregation card
In dual-card protection mode:
 Green: the card is primary.
 Off: the card is slave.
In non-protection mode: it is Green.
LOF alarm LED
 Red: input LOF alarms are generated on optical
interfaces 1, 2, 3, and 4.
 Off: no input LOF alarms are generated on optical
interfaces 1, 2, 3, and 4.
LOS alarm LED
 Red: input LOS alarms are generated on optical
interfaces 1, 2, 3, and 4.
 Off: no input LOS alarms are generated on optical
interfaces 1, 2, 3, and 4.
Set the rate of the first optical interface to STM-4;
others become invalid.
Set the rate of the four optical interface to STM-1.
The SDN interface on the backplane takes effect.
Meanwhile, the SDH interface on the front panel is
invalid.
The SDN interface on the front panel takes effect.
Meanwhile, the SDH interface on the backplane is
invalid.
13 EOP cards
Description
113