Dip Switches; Table 14-13 Configurations Of Dip Switch Sw1 On The Opcom3500E-4Eos-4Fx; Table 14-14 Configurations Of Dip Switch Sw2 On The Opcom3500E-4Eos-4Fx - Raisecom iTN2100 Hardware Description

Raisecom
iTN2100 (P100R002) Hardware Description
SD
(1–4)
LNK/ACT
(1–4)

14.3.5 DIP switches

Table 14-13 and Table 14-14 list configurations of DIP switches on the OPCOM3500E-
4EOS-4FX.

Table 14-13 Configurations of DIP switch SW1 on the OPCOM3500E-4EOS-4FX

DIP switch Function
SW1 Set working mode of
the card



Table 14-14 Configurations of DIP switch SW2 on the OPCOM3500E-4EOS-4FX

SW2
Interface Status
Green
Green
Bit1
ON
OFF
By default, SW1 is all OFF. Namely, the card is working in EOS mode by default.
After you set working mode of SW1, configurations take effect after power-on.
Configuring SW1 during power-on is not supported.
DIP Function
switch
Set the type
of optical
interface
device.
Raisecom Technology Co., Ltd.
Optical signal detection LED
 Green: optical signals are detected.

Off: no optical signals are detected.
Line working LED
 Green: the interface is working properly.

Off: the interface is disconnected or is working improperly.
 Blinking green: the interface is receiving or sending data.
Status
Bit2
ON Set the card in ESW working mode.
OFF Set the card in EOS working mode.
Status
Bit1 Bit2
ON ON
ON ON
ON ON
ON ON
ON OFF
ON OFF
ON OFF
Description
Description
Optical interface
Bit3 Bit4
ON ON M
ON OFF S1
OFF ON S2
OFF OFF S3
ON ON SS13
ON OFF SS15
OFF ON SS23
14 EOS cards
Description
device
125