Ethernet Cables; Introduction; Appearance; Figure 21-3 Fc/Pc Fiber Connector - Raisecom iTN2100 Hardware Description

Raisecom
iTN2100 (P100R002) Hardware Description
When connecting or removing the SC/PC optical connector, align the connector with the
optical interface, and do not rotate the fiber. Pay attention to the following points:


Figure 21-3 shows the FC/PC fiber connector used by the iTN2100.

Figure 21-3 FC/PC fiber connector

When connecting or removing the FC/PC optical connector, pay attention to the following
points:



21.2 Ethernet cables

21.2.1 Introduction

The Ethernet cable is used to connect:


The Ethernet interface on the iTN2100 supports self-adaptive straight-through cables and
cross-connect cables.
Ethernet cables need to be made on site.

21.2.2 Appearance

Figure 21-4 shows the Ethernet cable.
Align the head of the fiber jumper with the optical interface and insert the optical fiber
into the interface gently.
To remove the fiber, press the latch on the connector and pull the fiber out.
Align the head of the fiber jumper with the optical interface to avoid damaging the
ceramic inner tube, and insert the optical fiber into the interface gently to the bottom.
Then, rotate the screw set clockwise tightly.
To remove the fiber, rotate the screw set anticlockwise. When the screw set is loose, pull
the fiber out.
The Ethernet electrical interfaces on the iTN2100 and other devices.
The SNMP interface on the iTN2100 and the NMS network.
Raisecom Technology Co., Ltd.
21 Cables
246