Interfaces; Leds; Table 15-33 Interfaces On The Opcom3500E-120Fe× 4-Ge Panel; Table 15-34 Parameters Of The Eth Interface On The Opcom3500E-120Fe× 4-Ge - Raisecom iTN2100 Hardware Description

Raisecom
iTN2100 (P100R002) Hardware Description

15.7.3 Interfaces

Interface types
There are five interfaces on the OPCOM3500E-120FE× 4-GE panel, as listed in Table 15-33.
Table 15-33 Interfaces on the OPCOM3500E-120FE× 4-GE panel
Interface
ETH
A–D
Interface parameters
Table 15-34 lists parameters of the ETH interface on the OPCOM3500E-120FE× 4-GE.
Table 15-34 Parameters of the ETH interface on the OPCOM3500E-120FE× 4-GE
Connector type
Interface rate
Maximum
supported
frame length
Duplex mode
Flow control

15.7.4 LEDs

There are 14 LEDs on the OPCOM3500E-120FE× 4-GE panel, as listed in Table 15-35.
Table 15-35 LEDs on the OPCOM3500E-120FE× 4-GE panel
Interface
PWR
SYS
Type
RJ45
1× 9 optical interface
Parameter
RJ45
10/100/1000 Mbit/s or auto-negotiation
1632 Bytes
Full duplex/half duplex/auto-negotiation
 Full duplex: IEEE 802.3x-based flow control

Half duplex: back-pressure flow control
Status
Green
Green
Raisecom Technology Co., Ltd.
Service downlink interface

Service uplink interfaces
 TX indicates sending and RX indicates receiving.
Description
Power LED
 Green: the power supply is normal.

Off: the power supply is abnormal.
System status LED
 Green: the system is working improperly.

Off: the system is working improperly.
 Blinking green: the system is working properly.
15 PDH and RCMS cards
Description
Description
164