Dip Switches; Table 14-20 Configurations Of Dip Switch Sw2 On The Opcom3500E-8Eos-Fe - Raisecom iTN2100 Hardware Description

Raisecom
iTN2100 (P100R002) Hardware Description
ALM
100M
LNK
FDX
ACT

14.4.5 DIP switches

Table 14-20 and Table 14-21 list configurations of DIP switches on the OPCOM3500E-
8EOS-FE.

Table 14-20 Configurations of DIP switch SW2 on the OPCOM3500E-8EOS-FE

SW2
Interface Status
Red
Green
Green
Green
Green
DIP Function
switch
Set the type
of the
optical
interface
device.
Raisecom Technology Co., Ltd.
Alarm LED
 Red: TU-AIS or TU-LOP alarm are generated in VC-12.

Off: no TU-AIS or TU-LOP alarm are generated in VC-
12.
Ethernet electrical interface working LED

Green: the interface is working at 100 Mbit/s.
 Off: the interface is working at 10 Mbit/s or disconnected.
Link working LED

Green: the link interface is properly connected.
 Off: the link interface improperly connected or
disconnected.
Duplex mode LED
 Green: the Ethernet electrical interface is working in full
duplex mode.
 Off: the Ethernet electrical interface is working in half
duplex mode.
Data TX/RX LED
 Green: the interface is receiving or sending data.
 Off: the interface is not receiving or sending data.
Status
Bit1 Bit2 Bit3
ON ON ON
ON ON ON
ON ON OFF
ON ON OFF
ON OFF ON
ON OFF ON
ON OFF OFF
ON OFF OFF
Description
Description
Bit4 Optical interface
device
ON M
OFF S1
ON S2
OFF S3
ON SS13
OFF SS15
ON SS23
OFF SS25
14 EOS cards
129