Tip & Tool Stand - Pace ST 65 Operation & Maintenance Manual

Set-Up
Tip & Tool Stand
If you have purchased a system with a handpiece, set up the Tip & Tool Stand in the
following manner. If you have purchased another SensaTemp handpiece, use the
instructions enclosed with the handpiece and associated Tip & Tool Stand.
1. To attach the stand to the power
source, use the following procedure.
a) Insert the 2 Mounting Screws
(head first) into the 2 power
source mounting slots shown.
Slide the screws toward rear of
power source.
b) Place the Tip & Tool Stand beside
the power source. Insert ends of
the 2 Mounting Screws into the 2
Tip & Tool Stand mounting holes
shown.
c) Install a Thumb Nut onto the end
of each Mounting Screw. Tighten
Thumb Nuts to secure the stand
in position.
2. Place the handpiece into its Tip &
Tool Stand.
Handpiece Connection
Connect the handpiece connector plug into the Power
Receptacle in the following manner.
1. Align guide on connector with slot on power
receptacle.
2. Insert connector into power receptacle.
12