ASSEMBLY INSTRUCTIONS
Hydraulic Installation
NOTE
Refer to Figures 3-15 through 3-20 for hydraulic
diagrams for each model.
1. Install the manifold to the manifold bracket on the
frame using 1/2-13 x 3-1/2 hex head cap screws and
hex lock nuts.
2. Install fittings into manifold according to Figures 3-15
through 3-20.
3. Install wheel lift and disc gang lift system hoses per
Figures 3-15 through 3-20.
4. Install wing fold system hoses (2310-7-30 and -8-30)
per Figures 3-15 through 3-20.
3-26
Figure 3-21: Hitch Hose Clamps and Color Designation
5. Hold each system of hoses in place using 3/8-16 x 3
(2310-4-30, -5-24, -5-30, -6-24, -6-30, and -7-24
models) or 3/8-16 x 4-1/4 (2310-7-30 and -8-30
models) hex head cap screw, hose clamps, and hex
lock nut (See Figure 3-21.)
6. Install steel plugs in any remaining open manifold or
valve ports.
7. Install hose wraps around system hoses per hose
identification decal near hose couplers, putting both
hoses inside wrap(See Figure 3-21.) Note that no
yellow hose wrap is used on rigid models.
F-556-0910 Edition