Disc Gang Depth Gauge Assembly - Landoll Weatherproofer III 2310 Series Operator's Manual

Disc Gang Depth Gauge
Assembly
1. Connect depth gauge mount to disc gang bar using
wing stabilizer u-bolt and 5/8-11 hex lock nuts (See
Figure 3-14.) Leave hardware loose.
NOTE
See Figures 2-1 through 2-8 for depth gauge mount
placement.
2. Attach depth indicator gauge to the depth gauge
mount using 1/2-13 x 5-1/2 hex head cap screw and
hex lock nut.
3. Slide depth gauge indicator through slot in depth
gauge guide.
ASSEMBLY INSTRUCTIONS
4. Connect depth gauge guide and depth gauge bar to
the frame assembly using 1/2-13 x 5-1/2 hex head
cap screws and flange head serrated nuts.
5. Attach depth gauge decal to the top of the depth
indicator gauge.
NOTE
Slight adjustments may be needed in placement to
ensure that indicator does not bind up in both gang angle
settings.
6. Tighten all hardware to the recommended torques
shown in Table 2-1.
3-19