Landoll Weatherproofer III 2310 Series Operator's Manual page 37

8. Install rear disc gang in the same manner as
described in steps 4 thru 7 on page 3-14 (See
Figures 3-10 and 3-11).
9. Install radius rods as shown in Figures 3-6 thru 3-8.
Also, refer to Figures 2-1 thru 2-8 for radius rod
placement.
10. Hook each radius rod assembly up to the disc gang
lift as shown with a 1-8 x 8-1/2 hex head cap screw
and hex lock nut. There is a spacer tube that goes
between the two radius rod ball joints.
ASSEMBLY INSTRUCTIONS
Figure 3-10: Rear Disc Gang Installation
Figure 3-11: Rear Disc Gang Installation
3-15