Table of Contents
Advertisement
Final Assembly
1. Attach a tractor to the implement and charge the lift
system hydraulics as described in "Hydraulic Lift
System" on page 4-3.
2. Install the 1-1/2 x 16 lockouts on both 3-1/2 x 16
cylinders on the frame.
3. Connect lights to the tractor and verify operation.
4. Check tires for proper inflation
5. Level the Weatherproofer III from front to rear as
described in "Leveling (Front-to-Rear)" on
page 4-7.
6. Inspect the final implement assembly, and verify that
all bolts have been tightened, cotter pins spread, and
that there are no leaking hydraulic connections.
Tighten all 1-3/4" nuts to 1,200 foot-pounds of
torque (See Figure 3-23.)
CAUTION
ASSEMBLY INSTRUCTIONS
7. Rotate each disc gang to verify that each gang
rotates freely. Adjust any scrapers that may have
shifted during shipment or assembly.
8. Lubricate the Weatherproofer III at all locations (See
"Lubrication Maintenance" on page 4-17.)
9. Touch up with paint any areas that may have been
scratched during moving, handling, or assembly.
10. Thoroughly read and understand the operating
section before using the Weatherproofer III.
Figure 3-23: 1,200 Foot-Pounds of Torque
3-29
Hide quick links:
Advertisement
Table of Contents
