Field Operation; Leveling (Front-To-Rear) - Landoll Weatherproofer III 2310 Series Operator's Manual

Field Operation

1. Raise the unit to take the weight off of the transport
locks. Remove the transport locks from the lift
cylinders. Store the transport locks on the retainers
above the main lift (See Figure 4-7.)
Figure 4-7: Stored Transport Locks
OPERATION AND MAINTENANCE

Leveling (Front-to-Rear)

1. The leveling feature on the Weatherproofer III is used
to keep the machine level when raising the unit from
a working position to a transport position. The
leveling feature is also used to level the unit from
front-to-rear to perform a level operation in the field.
2. The unit should be level from front to rear. This will
reduce horsepower requirements, allow a more
uniform tillage operation, and reduce unnecessary
point wear.
3. To adjust the leveling feature, loosen jam nuts at
each end of the radius rod using the adjustment
wrenches (See Figure 4-8.) To raise the front of the
Weatherproofer III, lengthen the radius rod assembly.
To lower the front of the Weatherproofer III, shorten
the radius rod assembly. After adjusting, retighten
jam nuts at each end. Adjustments should be made
in small increments.
Figure 4-8: Radius Rod Leveling Adjustment
4-7