Rear Jack Installation - Landoll Weatherproofer III 2310 Series Operator's Manual

ASSEMBLY INSTRUCTIONS

Rear Jack Installation

A rear jack assembly is used on the rear of the
Weatherproofer III models. This is extremely helpful if an
attachment has been added to the rear of the machine for
stability.
1. Attach rear jack mount and rear jack plate to the rear
frame of the Weatherproofer III using 3/4-10 x 4 hex
head cap screws, flat washers, and hex lock nuts
(See Figure 3-24.)
IMPORTANT
The rear jack tube should be located to the rear of the
Weatherproofer III near the center of the frame.
2. Slide rear jack square tube into rear jack mount from
the bottom and hold in desired location with wing lock
pin, 1/4 x 3 slotted roll pin, and 3/16 hair pin.
3. Attach jack mount tube to rear jack square tube using
3/4-10 x 4 hex head cap screw and hex lock nut.
3-30
Figure 3-24: Rear Jack Installation
F-556-0910 Edition