Troubleshooting; Led Status Indicators - Christie H Series Service Manual

Troubleshooting

Use this section for troubleshooting process.

LED status indicators

The LED indicators are located on the front and rear of the projector. Each LED is defined in the
table below.
LED
Red (short blink)
Yellow (no blink)
LAMP LED
Green (no blink)
Green (short blink)
Off
Off
Blue (solid)
Blue (solid)
STATUS LED Green (flashing)
White (flashing)
Red (solid)
Red (flashing)
Off
SHUTTER LED
Magenta (solid)
H Series Service Manual
020-000802-03 Rev. 1 (12-2016)
Status
Failed to strike lamp after attempts (strike attempts will
stop)
Lamp has unexpectedly shut down (system goes into cool
down state)
Lamp time has expired and lamp should be replaced
(projector also begins to display the replace lamp OSD
message at startup)
Lamp is on and operating correctly
Projector lamp is switching on
Lamp is off
AC power is off (without AC plug in)
AC has been applied, projector is in standby mode
Projector is cooling down
Projector is startup or cool down mode
Projector is in flash (LAN) update state
Over-temperature
Fan failure
Lamp is on - image is displayed
Lamp is on - image is blank
Projector State
32