Calibrating The Lens - Christie H Series Service Manual

1. Place the projector on a clean horizontal surface.
2. Project bright mode, put cl200 in the center of image, measure the brightness of center.
3. Enter Factory Mode, see
4. Select ABC Feedback then press the Right button on remote.
5. Adjust the ABC adjustment gear by hex socket, let the frequency of image shows agree with
the table shows which corresponding the brightness value.
6. After completing the adjustment, tighten the screw on the side of the gear as indicated by the
yellow circle.

Calibrating the lens

Always perform a lens calibration after repairing the main board or replacing the light
i
engine.
Warning! Failure to comply with the following could result in death or serious injury.
• Do not stare into beam when the projector is on. The bright light may result in permanent
1 Inspection item
2 Criteria
To preform the lens calibration, complete the steps below.
1. Place the projector on a clean horizontal surface.
2. On the IR remote keypad, press Menu > Configuration > Lens Setting.
3. Select Lens Calibration.
4. Press Enter.
H Series Service Manual
020-000802-03 Rev. 1 (12-2016)
Entering factory mode
eye damage.
Check if the lens shift is moving smoothly.
The lens shift is moving smoothly.
on page 9.
Service setup
13