Service Mode; Entering Factory Mode; Entering Service Mode; Performing A Factory Reset - Christie H Series Service Manual

Service mode

D12HD-H, D12WU-H contain two kinds of modes: factory and service.

Entering factory mode

1. Turn on the projector.
2. On the remote or keypad, press the Auto, left, left, left buttons sequentially.

Entering service mode

1. Turn on the projector, do not input a signal.
2. press the Menu button.
3. Select Configuration and press Enter.
4. Select Service and press Enter.
5. On the IR remote keypad, press 4, 7, 5, 3 buttons sequentially, or on the keypad press left,
down, right, input.
6. Select OK and press Enter.

Performing a factory reset

Use this procedure to erase all end-user settings and restore the default on-screen display setting:
1. Enter Service Mode, as described in
2. Select Factory Reset.
Resetting the lamp used hours
Use this procedure to reset the lamp hour history:
1. On the Remote, press Menu.
2. Select "4. Lamp" by pressing Down button on the remote controller, and press Enter.
3. Select "Reset Lamp hours" by pressing Down button, and press Enter.
4. Select "1", "2" or "Both" by pressing Down button to reset the lamp hour.
H Series Service Manual
020-000802-03 Rev. 1 (12-2016)
Entering service mode
Service setup
on page 9.
9