Ptx1000 Ac Power Specifications - Juniper PTX1000 Hardware Manual

Table 12: PTX1000 Power Supply LED
Name Color State
Status Unlit Off
Green On steadily
Slow blinking
(1 Hz)
Blinking (2 Hz)
Amber On steadily
Blinking

PTX1000 AC Power Specifications

Table 13 on page 44 describes the AC power specifications for a PTX1000.
Table 13: PTX1000 AC Power Specifications
Item
AC input voltage
AC input line frequency
AC input current rating
Typical power consumption
Description
There is no power to any of the power supplies.
The power supply is on and operating correctly.
The power supply is in cold standby mode; only the 12 VDC input is present.
The power supply is uploading firmware.
Either the power cord is unplugged or a major error is detected in the power
supply. Examples of a major error are power supply failure, overvoltage
protection error, overcurrent protection error, a fan failure.
If the power cord is unplugged or missing, reattach the power cord
appropriate for your country.
If a major error is occurring, replace the power supply as soon as possible.
To maintain proper airflow through the chassis, leave the power supply
installed in the chassis until you are ready to replace it.
Warning events are being detected; the power supply continues to operate.
Often these events are because of rising temperatures. Check the fan
modules and the fans in the power supplies and ensure there is proper airflow
through the chassis.
Specifications
Operating range: 100–240 VAC
50–60 Hz
14 A at 100–120 VAC
1050 W
44