Connecting The Ptx1000 To External Devices; Connecting The Ptx1000 To A Management Ethernet Device - Juniper PTX1000 Hardware Manual

NOTE: The PTX1000 powers on as soon as power is provided to the power supply. There
is no power switch on the router.
8. Verify that the status LEDs on each power supply are lit green.
If the status LED is lit amber, remove power from the power supply, and replace the power supply (see
"Removing a Power Supply from the PTX1000" on page
you have a replacement power supply ready: the power supplies must be installed in the PTX1000 to
ensure proper airflow.
CAUTION:
seconds of removal to prevent chassis overheating.
SEE ALSO
PTX1000 DC Power Supply Description | 41

Connecting the PTX1000 to External Devices

IN THIS SECTION

Connecting the PTX1000 to a Management Ethernet Device | 89

Connecting the PTX1000 to a Management Console | 90
Connecting the PTX1000 to a Management Ethernet Device
You can monitor and manage the PTX1000 by using a dedicated management channel. The PTX1000 has
two management ports—a 10/100/1000BASE-T RJ-45 port for copper connections and a Gigabit Ethernet
SFP port for fiber-optic connections. Use the management ports to connect the PTX1000 to a network
for out-of-band management.
Replace a failed power supply with a new power supply within 30
101). Do not remove the power supply until
89