Juniper PTX1000 Hardware Manual page 95

Initiating vmhost halt... ok
Initiating Junos shutdown...
Shutdown NOW!
ok
Junos shutdown is in progress...
*** FINAL System shutdown message
System going down IMMEDIATELY
...
...
Operating system
Please press any key to reboot.
CAUTION:
PSM LEDs remain lit and a fan module continues to run. Wait at least 60 seconds
after first seeing this message before following the instructions in Step
5 to power off the PTX1000.
3. To prevent damage to the equipment caused by static discharge, attach an electrostatic discharge (ESD)
grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
4. Disconnect power to the PTX1000:
AC power supply—If the AC power source outlet has a power switch, set it to the off (O) position. If
the AC power source outlet does not have a power switch, gently pull out the male end of the power
cord connected to the power source outlet.
DC power supply—Switch the circuit breaker on the panel board that services the DC circuit to the
off position.
5. Remove the power source cable from the power supply faceplate:
AC power supply—Gently pull out the female end of the power plug connected to the power supply
faceplate.
DC power supply—Loosen the thumb screws for the power cable. Gently pull out the female end of
the power plug connected to the power supply faceplate.
RELATED DOCUMENTATION
shutdown: [pid 14318]
***
halted.
Although traffic and the operating system have stopped, the PTX1000
95
4 and Step