Juniper PTX1000 Hardware Manual page 84

3. Locate the power cord or cords shipped with the PTX1000; the cords have plugs appropriate for your
geographical location. See
WARNING:
or drape where people could trip over it.
4. Insert the coupler end of the power cord into the AC power cord inlet on the AC power supply faceplate
(see Figure 31 on page
Figure 31: Connecting an AC Power Cord to an AC Power Supply in a PTX1000
5. If the AC power source outlet has a power switch, set it to the off (O) position.
NOTE: The PTX1000 powers on as soon as power is provided to the power supply. There
is no power switch on the router.
6. Insert the power cord plug into an AC power source outlet.
7. Repeat Step 4 through Step
8. If the AC power source outlet has a power switch, set it to the on (|) position.
9. Verify that the status LEDs on each power supply are lit green.
If the status LED is lit amber, remove power from the power supply, and replace the power supply (see
"Removing a Power Supply from the PTX1000" on page
"PTX1000 AC Power Cord Specifications" on page
Ensure that the power cord does not block access to router components
84).
6 for each power supply that you are connecting to power.
45.
101). Do not remove the power supply until
84