Juniper PTX1000 Hardware Manual page 93

6. (Optional) Configure the name of the PTX1000. If the name includes spaces, enclose the name in
quotation marks (" ").
[edit]
root@# set system host-name host-name
7. Configure the default gateway.
[edit]
root@# set routing-options static route default next-hop address
8. Configure the IP address and prefix length for the management interface.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION:
interfaces within the same subnet, only one interface is usable and supported at a
time.
NOTE: The RJ-45 management port em0 and SFP management port em1 are both labeled
MGMT.
9. (Optional) Configure the static routes to remote prefixes with access to the management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain no-readvertise
10. Enable the Telnet service.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a PTX1000 through Telnet by using
root credentials. Root login is allowed only for SSH access.
11. Commit the configuration to activate it on the PTX1000.
Although the CLI permits you to configure two management Ethernet
93