3.Circle input
Operation points
▪ Designate circle input (
▪ Input three points (A circle, passing through the current position (already input) and two newly input
points, is created.)
Caution
[Example] The following type of sewing data will be created.
Operation details
(1)Inputting feed data to A point
►
Press
screen. After making the various settings on the Data
Setting Input screen, the Arrow Input screen will open.
(Refer to Page[6]-2)
►
Check that the code is set to FEED. If different code
is set, press
►
Press the arrow icons and move to the A point.
(Feed data to A point.)
(2)Setting feed data to A point
►
The movement amount can be confirmed.
►
Press
(Data on feed data to point A will be created.)
►
To change the stitching type to "Circle input", press
the input method setting icon.
(In this case, the
(3)Designating circle input
►
Press
►
Press
►
The system will return to the arrow input screen.
)
Note that the work holder will go back to the circle start position after the data is created.
and
on the Standard
and set the code to FEED.
to set the data.
icon.)
.
and set the data.
[7] - 8