Installation; Remote Mounting - Graco Matrix PAC 247436 Manual

Installation

(e)
(f)
(e) / (f)
15b
15a
F . 1
IG
1. Connect air line inlet to port (15a) (F
2. Connect pump air inlet to port (15b) (F
3. Tighten fittings securely.
4. Plug power cord in a grounded outlet.
312417F

Remote Mounting

Unless otherwise instructed, see F
numbers included in these instructions.
The PAC controller can be mounted in a remote, secure
location, away from the solenoid. The maximum dis-
tance the two components can be separated is 75 feet.
1. If the PAC power cord is plugged into an electric out-
2. Remove the 4 screws (7) from each corner of the
(c)
7
3. Inside PAC control box, disconnect P1 SOL (white),
4. Loosen cord grip (6) and completely remove cable.
5. Loosen screw (c) on the back of the mini DIN sole-
6. Remove screw (e) from front cover (f) on mini DIN
7. Inside mini DIN solenoid connector, disconnect
6
8. Loosen connector cord grip (d) and completely
9. Replace cable with a longer cable (75 feet maxi-
5
(d)
ti11960a
. 1) on PAC.
IG
. 1) on PAC.
IG
10. Inside PAC control box connect P1 SOL (white), P2
let, unplug power cord.
PAC cover and remove cover.
P2 SOL (black) and P3 GROUND (green) from ter-
minal block (See Wiring Diagram, page 7.)
noid connection and disconnect solenoid.
solenoid connection.
black wire from terminal labeled 1, white wire from
terminal labeled 2 and green wire from GROUND
terminal.
remove cable.
mum), feeding one end through cord grip (6) and
into inside of PAC control box and the other through
cord grip (d) and into mini DIN solenoid connection.
NOTE:
a. Replacement cable must be 18 AWG, pres-
sure extruded PVC jacket cable or hard usage
cord type "S" with STO standard PVC jacket
mini DIN solenoid
b. Connector (d) (Part No. 121048) is required to
connect cable to solenoid.
SOL (black) and P3 GROUND (green) to terminal
block (see Wiring Diagram, page 7).
Installation
. 1 for reference
IG
3