Ferno Integrated Patient Transport & Loading System iNX User Manual page 59

Mount Screw (8)
Loctite® 242 - 8x
Allow Loctite® threadlocker to dry for a minimum of one
hour before using the cot. Full cure time is eight hours.
© Ferno-Washington, Inc. / 234-3622-06 / March 2019
Oxygen Cylinder Mounts
Oxygen Cylinder Mount Assembly
NOTICE
Outer Position
Inner Position
Maintenance
ADJUSTING THE HOLDER
1. Use a 3 mm hex wrench to remove the four mount
screws from beneath each mount (Figure 66). Retain
the mount screws.
2. Align the mounts as needed based on the size of the
oxygen cylinder bottle (Figure 67).
3. Lay the cylinder-fastening straps across the assembly,
with the D-rings facing the control end of the iN∫X and
with the strap between the mounting holes for the
selected bumper mount location (Figure 66).
4. Prepare the eight mount screws and receiving threads
in the mounts:
Clean the threads of the screws, plus the receiving
○
threads in the mounts with acetone or an appropriate
Loctite® cleaner/primer (not supplied). Allow the
threads to dry completely.
○ Apply 1 drop of threadlocker (not supplied; recom-
mended: Loctite® 242 blue) to the threads of each
screw. Install the screws immediately. Wipe off any
excess threadlocker.
5. Use a 3 mm hex wrench to install and tighten four
mount screws into each mount (Figure 66).
INSTALLING THE HOLDER
1. Prepare the four short screws and receiving threads in
the hex spacers:
66
Clean the threads of the screws, plus the receiving
○
threads in the hex spacers with acetone or an
appropriate Loctite® cleaner/primer (not supplied).
Allow the threads to dry completely.
Apply 1 drop of threadlocker (not supplied; recom-
○
mended: Loctite® 242 blue) to the threads of each
screw. Install the screws immediately. Wipe off any
excess threadlocker.
2. Place a rubber washer on each hex spacer.
3. Insert the oxygen cylinder mount between the
telescoping frame sides and on top of the four hex
spacers. Confirm the oxygen cylinder mount is
properly seated on the hex spacers (Figure 65).
4. Place one small and one large washer on each short
screw and insert the screws through the oxygen
cylinder mount and into the hex spacers.
5. Use a 4 mm hex wrench to tighten the short screws.
6. Confirm the oxygen cylinder mount holds the cylinder
securely. See "Oxygen Cylinder Holder" on page 30.
67
59