Non-Powered Operation: Extending And Retracting - Ferno Integrated Patient Transport & Loading System iNX User Manual

Table of Contents

Advertisement

5.15 Non-Powered Operation:
Extending and Retracting
To extend or retract the iN∫X legs without power,
adjust each leg individually and by a small
amount. Repeat until the iN∫X is at the desired
height. Use additional help if needed; see "Using
Additional Help" on page 10. Refer to the
placement of operators in Figure 53 on page 45.
USING TWO OPERATORS:
PREPARING TO EXTEND OR RETRACT
Both Operators: Stand together at one end of the
1.
iN∫X and grasp the main frame. Communicate and
work together while extending or retracting the legs.
Do not place the patient at a severe angle.
2.
Both Operators: Raise the backrest and shock frame
(Figure 51) as needed. Release the actuator-release
handles from their mounts.
3.
Lead Operator: Grasp the main frame with both
hands, support and balance the iN∫X.
Handle Operator: Be ready to use the actuator-release
4.
handle at the proper time and assist with extending or
retracting the legs.
1.
Lead Operator: Lift the end of the iN∫X several inches
off the ground. Tell the handle-operator you are ready
for the position change.
Handle Operator: Squeeze the actuator-release
2.
handle (Figure 52) and push the legs down until
the transport wheels are on the ground. Release the
handle to lock the legs.
Lead Operator: Maintain your grasp on the iN∫X. Verify
3.
it is stable at the new position.
4.
Both Operators: Move to the opposite end of the iN∫X
and repeat Steps 1-3.
Both Operators/Helpers: Repeat Steps 1-4 until the
5.
iN∫X is level and is at the desired height.
Control the Load
Lift the iN∫X slightly before squeezing an
actuator-release handle. This ensures that
you are holding the load.
Non-Powered Recommendation
When extending the iN∫X without power,
Ferno recommends you begin at the loading
end. Raise the loading-end legs first, then
the control-end legs.
44
Using the iN∫X
EXTENDING
WARNING
Uncontrolled movement can cause injury or damage.
Support the load before using an actuator-release
handle.
A severe angle can injure the patient and/or operators.
Control the iN∫X when operating without power.
© Ferno-Washington, Inc. / 234-3622-06 / March 2019
51

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents