Ferno Integrated Patient Transport & Loading System iNX User Manual page 53

1 – ATTACH THE PELVIS STRAP
The pelvis straps have red webbing near the buckles (Figure
60). With the mattress removed, attach each bracket of the
Y-strap (two brackets per side) to the mounting posts at each
side of the seat panel. Verify the brackets are seated on the
posts and the strap is not twisted. Insert the retaining plugs.
2 – ATTACH THE CHEST/SHOULDER STRAPS
The chest straps have only black webbing and are connected
to the shoulder straps, which have red webbing near the links
(Figure 60). Attach the chest strap brackets to the mounting
post at each side of the backrest. Verify the brackets are
seated on the posts and the strap is not twisted. Insert the
retaining plugs.
3 – ATTACH THE LEG RESTRAINT
Each strap of the leg restraint has a loop. Guide the loop
through the restraint bracket on the iN∫X, then insert the
buckle (or tang) through the loop. Pull the strap to tighten
the strap against the restraint bracket (Figure 60).
60
© Ferno-Washington, Inc. / 234-3622-06 / March 2019
Maintenance
3
Restraint Bracket
REMOVING PATIENT RESTRAINTS
Unbuckle the patient restraints.
To detach the pelvis and chest/shoulder straps, use the
pull loop (Figure 59) to pull the retaining plugs out of the
brackets, then press the brackets down toward the main
frame to unseat the post from the bracket. Lift the bracket off
the post. If the brackets are difficult to remove, stand on the
opposite side of the iN∫X and pull across the patient surface.
To remove the leg restraint, unbuckle the restraint and feed
the buckle (or tang) through the loop. Then, remove the loop
from the restraint bracket.
1
Strap Keepers
The shoulder straps have elastic bands to
allow excess strap to be stored neatly.
2
Plug
Post
53