Telescoping Frame; Safety-Bar Release Levers - Ferno Integrated Patient Transport & Loading System iNX User Manual

4.20 Telescoping Frame

Use the telescoping frame (Figure 21) to shorten the iN∫X and
improve maneuverability in tight spaces (Figure 22). There
are two locked positions: extended and retracted. A third,
unlocked position fully retracts the frame to shorten the iN∫X
to its minimum length (when used with a raised backrest).
● Use only a locked position when lifting the iN∫X.
The telescoping frame must be locked in the extended
●
position before loading the iN∫X into an ambulance or
unloading the iN∫X from an ambulance.
● Do not lower the iN∫X to its minimum height with the
frame in the fully-retracted position.
USING THE TELESCOPING FRAME
1. Loosen or unbuckle the pelvis strap if needed.
2. Raise the backrest.
3. Adjust and fasten the pelvis strap.
4. Squeeze the telescoping frame release handle (Figure
21) toward the lift bar and begin pushing or pulling
the frame, then release the handle. Continue pushing
or pulling the frame until it locks at the new position.

4.21 Safety-Bar Release Levers

Use the safety-bar release levers to disengage each safety
bar from the safety hook.
A set of release levers is located on the telescoping frame
and on the loading-end legs (Figure 23).
Release each safety bar from the safety hook by turning the
bottom of the release lever away from the center of the iN∫X.
Also see "Loading the iN∫X" on page 38 and "Unloading the
iN∫X" on page 40.
Using Release Levers
Turn the bottom of the lever away from the
center of the iN∫X.
When standing at the patient left side, turn
the bottom of the lever counter-clockwise.
When standing at the patient right side, turn
the bottom of the lever clockwise.
26
Features and Controls
Safety-Bar
Release Lever
Telescoping Frame
Release Levers
© Ferno-Washington, Inc. / 234-3622-06 / March 2019
Lift Bar
21
22
Safety-Bar
Release Lever (2)
23