Power Switch; Light Buttons - Ferno Integrated Patient Transport & Loading System iNX User Manual

Turn the power OFF when the iN∫X will not be in use. For
extended storage, see "Storing the iN∫X" on page 54.
ON
OFF
3
Using Lights
● Drive Lights illuminate the ground around
the iN∫X to assist the operators.
● Surround Lights increase the visibility of the
iN∫X and the area around it.
4
© Ferno-Washington, Inc. / 234-3622-06 / March 2019
Features and Controls
NOTICE
Surround Light
(Each Side)
Drive Lights
(Each Actuator)

4.2 Power Switch

The power switch (Figure 3) is located on the right side of
the display. Keep the switch in the ON ( ) position for all iN∫X
operations.
If the iN∫X will not be used for more than 30 minutes, turn the
power switch OFF ( ) to conserve battery power.
After 10 minutes of non-use, the iN∫X will enter Sleep Mode
to conserve power. See "Sleep Mode" on page 22.
The iN∫LINE features a built-in Ferno® ICS® Integrated Charging
System. With ICS, the iN∫X power switch can be left ON. The
ICS disables the iN∫X powered mode and charges the battery.
See "Integrated Charging System (ICS)" on page 21.

4.3 Light Buttons

The iN∫X safety lighting system (Figure 4) provides light for the
terrain around the iN∫X and increases operator and patient
safety by increasing visibility of the iN∫X.
Surround Lights are white and red lights that span the
●
length of each side of the iN∫X to increase visibility of
the iN∫X. These lights can flash or provide steady light.
Drive Lights are affixed to each actuator and provide
●
steady light to illuminate the terrain around the iN∫X.


Note: Surround Lights and Drive Lights are ON or OFF at the
same time. Lights also turn OFF when the iN∫X enters Sleep Mode.
See "Sleep Mode" on page 22.
The iN∫X safety lighting system is controlled by two buttons.
An LED in the upper-right corner of the button indicates the
active lights.
SCENE LIGHTS
Press ON. The Drive Lights and Surround Lights
illuminate with steady white light.
Press OFF: All lights OFF.
EMERGENCY LIGHTS
Press ON. The Drive Lights illuminate with steady
white light. The Surround Lights illuminate and
flash in a sequence of red-red-white.
Press OFF: All lights OFF.
17