6.12 Storing the iN∫X
1.
Lower the iN∫X to the fully-retracted position (Figure
61)and turn the power switch OFF.
2.
Remove and charge the battery. See "Charging the
Battery" on page 54 and "Storing the Battery" below.
3.
Cover the battery cable connector on the iN∫X with a
bag. Seal the bag (for example, with a rubber band) to
prevent moisture from entering the connector.
Before returning the iN∫X to service:
1.
Attach a fully-charged battery.
2.
Turn the power switch ON.
3.
Have your service's equipment maintenance personnel
inspect the iN∫X. See "Inspecting the IN∫X" on page 48.
6.13 Charging the Battery
There are two ways to charge the battery: Secure the iN∫X in
the iN∫LINE (equipped with the Integrated Charging System),
or remove and connect the battery directly to a Ferno battery
charger.
To charge the battery using the iN∫LINE: Verify the
●
ambulance power to the iN∫LINE ICS is ON and secure
the iN∫X in the iN∫LINE. See "Integrated Charging System
(ICS)" on page 21.
To charge the battery using the charger: Remove the
●
battery from the iN∫X and connect it to a Ferno® battery
charger. See "Battery" on page 20.
To store the battery if it will not be used for an extended
●
period of time, see "Storing the Battery" below.
The battery is water-resistant and is suitable for outdoor
●
use. Do not submerge the battery in water.
To clean the battery, wipe the battery port with a clean
●
dry cloth if it becomes dirty or wet.
Do not open the sealed battery case. Do not dismantle,
●
open or shred the battery.
Recycle the battery when it can no longer maintain a
●
charge. Do not dispose of batteries with municipal
waste. See "Recycling Notice" on page 55.
Replace a damaged or cracked battery.
●
6.14 Storing the Battery
Fully-charge the battery before storing it. Do not store
●
the battery with less than a full charge.
Store the battery only in a cool, dry place. Battery capacity
●
can be affected if the battery is stored for long periods
outside of the recommended temperature range.
After an extended period of storage, charge the battery
●
fully before use.
54
BATTERY CARE
Maintenance
Deeply-Discharged Battery
If the battery is deeply discharged, the
ICS may not be able to charge the battery.
Connect the battery directly to the charger
separate from the ambulance and ICS.
Charging Inside an Ambulance
To charge a battery inside an ambulance, the
Ferno® ICS® must be used.
© Ferno-Washington, Inc. / 234-3622-06 / March 2019
61