Ferno Integrated Patient Transport & Loading System iNX User Manual page 39

Table of Contents

Advertisement

40
Safety Bar
Safety Hook
41
42
43
© Ferno-Washington, Inc. / 234-3622-06 / March 2019
Using the iN∫X
9.
Control-end Operator: The display shows the loading-
end legs green (ready to retract) and control-end legs
white (will not retract). Press
the loading-end legs (Figure 40).

Note:
The iN∫X has a leg "kick-up" feature to position the control
end slightly above the level of the ambulance floor. This feature
helps aid a smooth transition into the ambulance and reduces
bumps for the patient and operators as each set of wheels rolls
into the ambulance.
10. Both Operators: Push the iN∫X into the ambulance
until the intermediate wheels and position indicator
lights are on the ambulance floor and the intermediate
safety bar passes the safety hook, then stop (Figure 41).
Press
11. Loading-end Operator: Visually confirm the inter-
mediate safety bar has captured the safety hook. If
needed, use the release lever to lift the safety bar
over the safety hook, and then lower the safety bar to
engage the safety hook Figure 41).
12. Both Operators: Pull the iN∫X against the safety
hook to confirm the intermediate safety bar has been
captured by the hook.
13. Control-end Operator: Press to begin retracting the
Release Lever
control-end legs (Figure 42).
Note: The legs will retract slightly, then stop when they
are no longer supporting the weight of the iN∫X. This is
a safety check to verify that the load is being supported.
14. Control-end Operator: Press
control-end legs.
15. Both Operators: Push the iN∫X into the ambulance
(Figure 43) until:
the loading-end fastener post is captured in the
iN∫LINE fastening system lock, and
the control-end fastening post slides into the iN∫LINE
fastening post retainer channel.
Legs Pause (Loading Process)
Each set of legs will retract slightly and then
stop retracting when they are no longer
supporting the weight of the iN∫X. This is a
safety check to verify the weight is supported
by the ambulance and/or operator(s).
Position Indicator Lights
When the red line is visible on the
ambulance floor, the intermediate loading
wheels are also on the ambulance floor,
indicating it is safe to retract the control-
end legs.
Use the Telescoping Handles
Extend the telescoping handles to more
easily maneuver the iN∫X into the iN∫LINE
and reduce the amount of reaching
required. Retract the handles before closing
the ambulance rear doors.
and completely retract
to lower the intermediate wheels to the floor.
to finish retracting the
39

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents