Extend And Retract Buttons; Sleep Mode - Ferno Integrated Patient Transport & Loading System iNX User Manual

4.13 Extend and Retract Buttons

Two sets of Extend and Retract buttons are affixed to the
control end of the iN∫X, where they are accessible to the
operator's right hand. One set is affixed to the telescoping
handle, while the other set is affixed to the guide bar (Figure
13). The function of each set of buttons is identical.
AUTO-EQUALIZING FEATURE
When a button is pressed, one set of legs extends or retracts
until both sets of legs are equally-extended. Continue pressing
the button to extend or retract the iN∫X.
EXTEND: If the legs are not equally extended, the
more-retracted set of legs extends to equalize the legs.
Then, both sets of legs extend together.
RETRACT: If the legs are not equally extended, the
more-extended set of legs retracts to equalize the legs.
Then, both sets of legs retract together.
In addition to stopping at the maximum and minimum
heights, the iN∫X stops automatically when it reaches the
factory-set maximum recommended transport height and
the user-set loading height.
When the iN∫X stops at the transport or loading height, press
or again to continue extending or retracting the legs.
Note:

The iN∫X stops at the user-set loading height only when
extending. To set the loading height, see "Set the Loading Height"
on page 61.
LOADING AND UNLOADING
If the iN∫X is being supported by the ambulance floor,
pressing or will extend or retract only one set of legs at
a time. See "Loading the iN∫X" on page 38 and "Unloading
the iN∫X" on page 40.

4.14 Sleep Mode

Sleep Mode conserves battery power. If the iN∫X is not in use
for more then 10 minutes (no buttons pressed), the system
enters Sleep Mode. In Sleep Mode, the display and all lights
are OFF.
Press the button to activate the iN∫X. When the display is
active, press or
22
Features and Controls
STOPS
to extend or retract the legs.
Automatic Stops
The iN∫X automatically stops at:
● the factory-set maximum transport height
● the user-set loading height
To continue, re-press or .
Press Green to Go
To activate the iN∫X after turning the power
switch ON, or to wake the iN∫X from Sleep
Mode, press . Note: Only the button will
activate/wake up the iN∫X.
© Ferno-Washington, Inc. / 234-3622-06 / March 2019
Buttons (2 sets)
Extend Legs
Retract Legs
13