Ferno Integrated Patient Transport & Loading System iNX User Manual page 45

Actuator-Release Handle
52
Non-Powered Operation:
Extending and Retracting (with Patient)
Non-Powered Operation:
Extending and Retracting (No Patient)
53
© Ferno-Washington, Inc. / 234-3622-06 / March 2019
Using the iN∫X
1. Lead Operator: Lift until the wheels are off the ground
to confirm you are holding the load. Communicate to
the handle-operator that you are ready for the position
change.
2. Handle Operator: Grasp the main frame and handle.
Both operators: As the handle operator squeezes
3.
the handle, both operators assist the retracting
process. Release the handle to lock the legs.
4. Lead Operator: Maintain your grasp on the iN∫X. Verify
it is stable at the new position.
Both Operators: Move to the opposite end of the iN∫X
5.
and repeat Steps 1-4.
6. Both Operators: Repeat Steps 1-5 until the iN∫X is
level and is at the desired height.
FOLDING WITHOUT A PATIENT
To fold the iN∫X with no patient, the operators stand at
opposite ends of the iN∫X and squeeze the handles at the
same time. Control the descent of the iN∫X and keep it level
as you fold it.
Deploying the Handles
Push the base of the actuator-release
handle to remove it from its mount. Position
the loading-end handle at the patient-right
side of the iN∫X, and the control-end handle
at the patient-left side.
Non-Powered Recommendation
When retracting the iN∫X without power,
Ferno recommends you begin at the control
end. Lower the control-end legs first, then the
loading-end legs.
RETRACTING
45