Lubricating The In∫X - Ferno Integrated Patient Transport & Loading System iNX User Manual

Lubricating parts that should not be lubricated allows dirt
and foreign particles to collect on those parts, resulting in
damage. Lubricate only the numbered reference points
shown.
57
© Ferno-Washington, Inc. / 234-3622-06 / March 2019
NOTICE
Lubricate in Slot (Both Sides)
Lubricate (Both Sides, Both Ends)
2
Maintenance
6.10 Lubricating the iN∫X
Disinfect and clean the iN∫X before applying lubricant.
Use the lubricants designated below to lubricate. Do not
lubricate points marked with the "do not lubricate" symbol.
1. Safety Bar Pivot (x2) WRL-191S, E-Z-1 light oil
2. Slider Rails
LUBRICATION-FREE ITEMS
Wheels (sealed bearings)
Legs
Patient Surface
Safety-Bar Pivot Points: Apply a few drops of lubricant as
needed (near the red handle). Wipe off any excess.
Sliding Rails: If the sliding rails squeak during use, clean the
rails. If this does not solve the problem, clean and then apply
a light coating of PTFE dry-film spray lubricant to the rails.
*PTFE is the generic name of products similar to Teflon® (a
registered trademark of the DuPont Company, E. I. du Pont
de Nemours and Company or its affiliates.)
1
Applying Lubricant
Use a small amount of lubricant (one or two
drops). Lubricate identical points on each
side of the iN∫X. After applying lubricant,
wipe off any excess.
LUBRICATION POINTS
PTFE* dry-film spray lubricant
Do not lubricate
Do not lubricate
Do not lubricate
Do Not Lubricate
Lubricate
51