IBM 5280 Manual page 70

Q R
5 5
047
DATA ENTRY MAP
ENTRY
PAGE 6 OF 7
This is a display failure, go
to MAP 1000, Entry Point B,
for further isolation.
048
- Power of-f.
- 'IPL', using Diagnostic
Diskette 1, from Data Station 0
(MIM941).
- Do not use the current
definition.
- Select a single partition.
- Select 'Dep' (MIM 951).
- Select and run MDI 1060 (MIM
961).
Was the failure found by MDI
1060?
Y N
049
- Select and run MDI 1070 (MIM
961).
Was the failure found by MDI
1070?
Y N
050
GO TO MAP 0100,
ENTRY POINT A.
051
End of call.
052
End of call.
P
5
MAP 1000-6
053
Power off.
- Wait approximately 30 seconds.
- When the First Prompt (50-01)
(MIM 941) is displayed on Data
Station 0, press the
YX'
key
and then the ENTER key.
- When the Keyboard Information
Prompt (50-02) (MIM 941) is
displayed, record the number of
keyboards displayed on the
screen.
Does the number of keyboards
displayed on the screen match the
number of keyboards installed on
the system?
Y N
054
- This is a 9120 error.
GO TO MAP 1025, ENTRY POINT A.
055
- Press the ENTER key.
Prompt (50-03) (MIM 941) wi 11
be displayed.
- Select the 'No' option.
Select the correct display size
for each foreground partition
as the prompts are displayed.
- Press the SYS REQ,
2,
and
z
keys on Data Station O.
Is the Load Prompt displayed on
Data Station O?
Y N
056
- This is a display failure.
GO TO PAGE 2, STEP 004,
ENTRY POINT B.
057
GO TO PAGE
4,
STEP
024,
ENTRY POINT D.
EC840847 PEC839787
MAP 1000-6