Signals; Application Information - Siemens SIMADYN D Hardware Manual

Program memory modules / Interface modules
Green LED
Red LED

8.5.1 Signals

Yellow LED
NOTE

8.5.2 Application information

Other information
8-18
www.aotewell.com
The SIMADYN D power supply is indicated using a green LED (P).
The SIMADYN D power supply (1P, 1M) is short-circuited (fault
condition).
Signals up to a maximum of 120 V (nominal value) DC or AC can be
connected at the SB60 interface module.
The status of the binary interface module outputs (binary inputs for
SIMADYN D) is indicated using yellow LEDs (1...8).
There are two screw connections for each signal at
terminal strip X2:
• terminals 12, 22, ... up to 82 for binary signals 120 V
• terminals 11, 21, ... up to 81 for the reference point
To connect the signal lines to the terminals see "User manual FM 458-1
DP" chapter "Installation and EMC guideline".
The interface module can only be vertically mounted due to the power
loss which has to be dissipated.
Further information on EMC and ambient conditions, refer to Section
„General technical data"
sales@aotewell.com
Industry Automation
Hardware - SIMADYN D
Edition 04.2011
+86-755-8660-6182