Battery Change; Connecting Elements - Siemens SIMADYN D Hardware Manual

Operator control panel OP2
10.9

Battery change

NOTE
Changing the
battery:
WARNING
!
DANGER

10.10 Connecting elements

10-26
www.aotewell.com
The lithium battery is used to back-up the operating data in the static RAM
and to supply the CMOS clock module when the power supply is off.
The battery may only be changed with the power supply voltage
powered-up in order to prevent data loss!
1. Remove the battery cover and remove the battery from its holder.
2. Remove the battery connector from the cable
3. Insert the new battery in the reverse order
Observe the EMC guidelines and the safety-related information.
Ordering spare parts:
Siemens AG, Gerätewerk-Karlsruhe
Lithium battery 3.6 V, 1800 mAh, Order No.: W79084-E-1001-B2
• For safety reasons, it is not permissible that lithium batteries are in
the equipment when it is transported unless the battery
manufacturer permits this expressly using an appropriate
declaration.
• When the equipment is stored and shipped, the batteries must be
individually and separately packed in a non-conductive material.
• There is a danger of explosion if they are not correctly handled. We
can accept no liability for incorrectly handled batteries.
• Used batteries must be disposed of in compliance with national and
European legislation and regulations.
• The lithium batteries must be removed from the battery holder
before the subrack or power supply is disposed of.
O P 2
( L o w e r s id e o f th e u n it)
T e r m in a l b lo c k / p o w e r s u p p ly
sales@aotewell.com
P r in te r
D R 2 1 0 /2 1 1 -N , D R 2 3 0 /2 3 1 - N
V .2 4 /T T Y
S S 1 /IF 1
N o t u s e d (V .2 4 /T T Y )
Industry Automation
S IM A D Y N D
R S 4 8 5
S S 2 A /IF 2 A
S S 2 B /IF 2 B
G ro u n d c o n n e c tio n
Hardware - SIMADYN D
Edition 03.2001
+86-755-8660-6182
U S S m a s te r
U S S -