Parameters; Terminal Assignment - Siemens SIMADYN D Hardware Manual

Technology subrack
Synchronizing
2 T400:

7.2.7 Parameters

7.2.8 Terminal assignment

7-10
www.aotewell.com
BASE BOARD-T400, synchronized via X2/B25 --> X1/B25 TECH BOARD-
T400, and
TECH BOARD-T400 synchronized via X1/A26 --> X2/A26 BASE BOARD-
T400;
The I/O of the function blocks as well as the parameters can be defined
(configured) on the T400. Thus, these I/O can be read and changed using
the "parameter mechanism" via
• Dual port RAM
• PROFIBUS (CB1)
• USS protocol (for operator control device, SIMOVIS)
2000 parameters can be configured, whereby a differentiation can be made
between those at the operator control panel (and SIMOVIS), and the basic
drive converter parameters („r" and „P") using one of the two prefixes
• „H"
• „L"
All of the signals are connected at 55 terminals, which are accessible from
the front.
They are distributed over 5 11-pin MINI-COMBICON plug connectors in a
3.5 mm grid dimension (connectors X5 - X9):
sales@aotewell.com
Industry Automation
Hardware - SIMADYN D
Edition 03.2001
+86-755-8660-6182