Application Information And Noise Immunity; Connector Assignment Of The Interfaces - Siemens SIMADYN D Hardware Manual

Aotewell Ltd
Reset button
LED

6.2.1 Application information and noise immunity

Other information

6.2.2 Connector assignment of the interfaces

Parameterizing
interface X5
Hardware - SIMADYN D
Edition 12.2004
HongKong|UK|China
www.aotewell.com
The CP1470 can be reset using the reset button. The switch must first be
set to "ADM".
Green Red Significance
Dark Dark No power supply;
temporary initialization status
Lit Dark Database and synchronization O.K.
Flashi Dark Database inconsistent; correct NML configuring
ng
Dark Lit No synchronization with the initializing CPU module;
possible cause: @CSH11 function block not configured,
incorrect slot or incompatible firmware
Dark Flashin Hardware fault
g
Flashi Lit Switch in the STOP setting or ADM
ng
The function of the LEDs is also described in the User Instructions
„Configuring the communications".
• the module may only be used in forced-ventilated subracks.
• the serial connecting cables must be latched-in using the latching
mechanisms provided.
• noise-immune operation is only possible if the module is tightly screwed
into the subrack
Further information on EMC and ambient conditions, refer to Section
„General technical data".
25-pin sub D socket connector
Pin RS-232 TTY
1 Screen ----
2 TxD ----
3 RxD ----
7 Ground ----
9 ---- +RxD
10 ---- -RxD
18 ---- +TxD
21 ---- -TxD
sales@aotewell.com
Industry Automation
Communications support modules
+86-755-8660-6182
6
6-13