Operator Control Overview For Process Data Handling - Siemens SIMADYN D Hardware Manual

Operator control panel OP2
10.2.3

Operator control overview for process data handling

VAL: Displays process data
VAL
- The two last selected process data are displayed (Default: VALUE V1 and V2)
SEL
SEL: Selects process data
- The select functions V1...V12/SHFT/DIM are activated
- The designator in the active display line flashes
- The active display line changes if the key is again depressed
CHG
CHG: Changes setpoints
- The change mode for the selected process data is enabled
- A change currently being made is cancelled
- Operating message No. 5 "SETPOINT CHANGE INHIBITED", if an ACTUAL VALUE was selected
(configured)
Decrease
value
Changing a value using the continuous
change keys and TIP operation
EPROM
E2 PROM: Saving changes in the SIMADYN D EPROM
- Activate the memory function
- The LED flashes until the function has been completed with Enter
- Operating message No. 35 "SAVE EPROM UNSUCCESSFUL". A value
is not accepted if there is an error condition
Value transfer
Enter
10-4
www.aotewell.com
V1 V2
...
Selects process data
V1...V12: Measured value 1...24
Increase
value
SYSTEM
sales@aotewell.com
SHIFT DIM
SHIFT: Toggles DIM: Toggling the
representation type
between the process
data panels between values with
dimension and value as
LED dark: V1...V12
a percentage
LED lit: V13...V24
Numerical
keypad
Correction
backspace key
Cursor position
Enter
Entering a new value
Running functions are CANCELED
SYS
MSG BIN
MSG
Industry Automation
Entering a new value
Toggling between
mantisse and exponent
for floating-point number
Cursor position
Terminate and transfer
the change
VAL
Return to
display operation
Hardware - SIMADYN D
Edition 03.2001
+86-755-8660-6182