Siemens SIMADYN D Hardware Manual page 233

Aotewell Ltd
Position of the
jumpers
NOTE
Other information
Hardware - SIMADYN D
Edition 04.2011
HongKong|UK|China
www.aotewell.com
The jumpers (short-circuit connectors) are located in the section of the
housing cover facing away from the LEDs. These are only accessible
after the interface module has been removed.
The potential assignment between the plant- and system side is defined
as follows:
Reference potential of the inputs
Inputs are additionally electrically-
isolated with respect to one another
Inputs with common reference
potential
1)
n = number of input 1 to 8
Table 8-6 Position of the jumpers
The potential reference can be separately set for each input.
The interface module can only be mounted vertically due to the power
loss which has to be dissipated.
Further information on EMC and ambient conditions, refer to Section
„General technical data"
A typical application is shown in the following diagram:
Fig. 8-11 Application example for interface module SB61 at the binary input-, output
module EB11
sales@aotewell.com
Program memory modules / Interface modules
Position of the short-circuit
connector (jumper)
1)
Connector X1n
Connector X1n :1:2 and X1n :3:4
inserted
Industry Automation
:2:3 inserted
8-25
+86-755-8660-6182
8