Installing / Removing And Connecting Analyzer And Option Modules; General Safety Instructions For Configuration Change - Siemens SIPROCESS GA700 Operating Instructions Manual

Installing / removing and connecting analyzer and
option modules
7.1

General safety instructions for configuration change

Dangerous voltage at open device
Danger of electrocution when the enclosure is opened or enclosure parts are removed
• Keep the device closed during operation
• Open the enclosure exclusively for installation or maintenance. Close the enclosure
• Disconnect the device before you open the enclosure or remove enclosure parts.
• Observe the special precautionary measures if maintenance is required while the device
Hot surfaces resulting from hot sample gases and high-temperature devices
After being switched off the analyzer module or the heated device respectively is still very
hot.
• Do not remove the analyzer module until after the analyzer module or device
• Take appropriate protective measures, for example contact protection.
NOTICE
Damage to the membrane keyboard and the display
Make sure when installing the device that the membrane keyboard and display are not
damaged.
NOTICE
Incorrect installation
Improper installation or modification can damage the device and thus invalidate the
approval.
Wall-mounted device
Operating Instructions, 05/2018, A5E31930403-06
WARNING
after the completion of this work.
is live. Have maintenance work carried out by qualified personnel.
CAUTION
respectively has cooled down.
7
59