Installing "Options" Terminal Block - Siemens SIPROCESS GA700 Operating Instructions Manual

Installing / removing and connecting analyzer and option modules
7.7 Installing option modules
4. Insert the option module
plate
Fasten the option module with the two screws
5. Insert the printed circuit board holder
Tighten the screw
6. Fit the electronics base plate
panel of the wall-mounted device.
Tighten the screws
7.7.3

Installing "Options" terminal block

Note
Subsequent installation of an option module
If you are installing an option module OM 1.1 or OM 2.2 into the wall-mounted device at a
later time, you need their connection for the "Options" terminal block.
72
①
at the respective mounting location into the electronics base
⑥
.
②
with a torque of 2.0 Nm.
④ ⑦
and
⑤
with a torque of 1.3 Nm.
③
again.
⑥
with the two screws
with a torque of 2.0 Nm.
Operating Instructions, 05/2018, A5E31930403-06
④ ⑦
and at the rear panel and side
Wall-mounted device