Device/Module Identification; Nameplate Layout - Siemens SIPROCESS GA700 Operating Instructions Manual

The device is attached to the wall with four screws, see section "Installing the wall-mounted
device (Page 56)".
The door
②
with six screws.
The device provides space for the installation of two unheated analyzer modules AM1
and AM2
installed since they use both slots AM1
You can find more information on the mounting locations of the option modules in the section
"Mounting locations of option modules (Page 68)".
The interior rear wall of the enclosure contains a power supply unit
processing unit
right.
At the underside of the device there are cable glands for the power supply cord
signal cable
and two optional connections for purge gas: Purge gas inlet
4.3

Device/module identification

4.3.1

Nameplate layout

①
②
③
Figure 4-2
The nameplate with the article number and other important information is located on top of
the enclosure exterior.
Wall-mounted device
Operating Instructions, 05/2018, A5E31930403-06
①
is fitted with a display
⑬
and two option modules. Due to their size only single analyzer modules can be
⑤
. A shield plate
⑧
and the Ethernet
Article number
Serial number
Revision status
Nameplate
③ ④
and a keyboard
⑭ ⑬
and AM2 .
⑥
for signal cables is fastened in the enclosure on the
⑨
as well as a connection to the equipotential bonding
④
DataMatrix Code ECC 200
⑤
Date of manufacture
4.3 Device/module identification
and is locked via mounting holes
⑦
and before it a
⑫
⑮
and purge gas outlet
Description
⑭
, the
⑪
⑩
.
23