Agilent Technologies E4406A VSA Series Programmer's Manual page 389

(-321) Out of memory
Indicates that an internal operation needed more
memory than was available.
If this occurs during a memory catalog display, it means
the system did not have enough free RAM to prepare
the catalog.
(-320) Storage fault
Indicates that the firmware detected a fault when using
data storage. This error is not an indication of physical
damage or failure of any mass storage element.
(-315) Configuration memory lost
Indicates that non-volatile configuration data saved by
the device has been lost. The meaning of this error is
device-dependent.
(-314) Save/recall memory loss
Indicates that the non-volatile data saved by the *SAV?
command has been lost.
(-313) Calibration memory lost
Indicates that non-volatile calibration data has been
lost.
(-312) PUD memory lost
Indicates that the protected user data saved by the
*PUD command has been lost.
(-311) Memory error
Indicates that an error was detected in the device's
memory.
(-310) System error
Indicates that an error, termed "system error" by the
device, has occurred.
(-300) Device-specific error
This is a generic device-dependent error for devices
that cannot detect more specific errors. The code
indicates only that a device-dependent error as defined
in IEEE 488.2, 11.5.1.1.6 has occurred.
Chapter 6
Error Messages
Error Message Descriptions
389