Spectrum (Frequency-Domain) Measurement - Agilent Technologies E4406A VSA Series Programmer's Manual

Spectrum (Frequency-Domain) Measurement

Commands for querying the spectrum measurement results and for
setting to the default values are found in the
Commands" on page
parameters described in the following commands, are found under the
key, after the
Meas Setup
selected from the
MEASURE
Spectrum—Data Acquisition Packing
[:SENSe]:SPECtrum:ACQuisition:PACKing
AUTO|LONG|MEDium|SHORt
[:SENSe]:SPECtrum:ACQuisition:PACKing?
Select the amount of data acquisition packing. This is an advanced
control that normally does not need to be changed.
Factory Preset
and *RST: Auto
Remarks: To use this command, the appropriate mode should be
selected with INSTrument:SELect.
Spectrum—ADC Dither
[:SENSe]:SPECtrum:ADC:DITHer[:STATe] AUTO|ON|OFF|2|1|0
[:SENSe]:SPECtrum:ADC:DITHer[:STATe]?
Turn the ADC dither on or off. This is an advanced control that
normally does not need to be changed.
Factory Preset
and *RST: Auto
Remarks: To use this command, the appropriate mode should be
selected with INSTrument:SELect.
Chapter 5
233. The equivalent front panel keys for the
Spectrum (Freq Domain)
key menu.
Language Reference
SENSe Subsystem
"MEASure Group of
measurement has been
325