Agilent Technologies E4406A VSA Series Programmer's Manual page 284

Language Reference
SENSe Subsystem
Defines the type of testing to be done at any custom offset frequencies.
The measured powers are tested against the absolute values defined
with [:SENSe]:ACP:OFFSet[n]:LIST[n]:ABSolute, or the relative values
defined with [:SENSe]:ACP:OFFSet[n]:LIST[n]:RPSDensity and
[:SENSe]:ACP:OFFSet[n]:LIST[n]:RCARrier.
You can turn off (not use) specific offsets with the
[:SENS]:ACP:OFFSet[n]:LIST[n]:STATe command.
Offset[n]
List[n]
cdmaOne mode n=1 is cellular bands and 2 is pcs bands. The default is
W-CDMA (Trial
& Arib) mode
The types of testing that can be done for each offset include:
• Absolute - Test the absolute power measurement. If it fails, then
return a failure for the measurement at this offset.
• And - Test both the absolute power measurement and the power
relative to the carrier. If they both fail, then return a failure for the
measurement at this offset.
• Or - Test both the absolute power measurement and the power
relative to the carrier. If either one fails, then return a failure for the
measurement at this offset.
• Relative - Test the power relative to the carrier. If it fails, then
return a failure for the measurement at this offset.
Factory Preset
and *RST:
Mode Variant
iDEN
Basic
cdmaOne BS cellular
BS pcs
MS cellular
MS pcs
cdma2000
284
n=1 is base station and 2 is mobiles. The default is base
station (1).
cellular.
n=1 is ARIB, 2 is 3GPP, and 3 is Trial. The default is
ARIB (1).
Offset A Offset B
REL n/a
REL REL
REL REL
REL ABS
REL REL
REL ABS
REL REL
Offset C Offset D
n/a n/a
REL REL
REL REL
ABS REL
REL REL
ABS REL
REL REL
Offset E
n/a
REL
REL
REL
REL
REL
REL
Chapter 5