Procedure B - YASKAWA SI-EP3 Technical Manual

5 Installation Procedure
7.
Use both CN1 port 1 and CN1 port 2 at the same time to daisy chain a series of drives where applicable.
8.
Reattach the front cover (A), terminal cover (C), and keypad (B).
Refer to the drive manuals for more information.
NOTICE
erroneous operation.
A - Drive front cover
B - Keypad
9.
Set drive parameters in
■

Procedure B

This section shows the procedure to install and wire the option on a GA700, GA800, CR700, or CH700 drive.
Prepare the Drive for the Option
Before you install the option on a YASKAWA AC Drive GA700, GA800, CR700, or CH700, make sure that the
option software version is PRG: 4400 or later.
Correctly wire the drive as specified by the manual packaged with the drive. Make sure that the drive functions
correctly. For information about drive connection and wiring, refer to the manuals for the drive on which you will
use this option.
16
Do not pinch cables between the front covers and the drive. Failure to comply could cause
Figure 5.7 Replace the Front Cover, Terminal Cover, and Keypad
Related Drive Parameters on page 25
C - Drive terminal cover
for correct option performance.
YASKAWA SIEP C730600 89E PROFINET Technical Manual