YASKAWA SI-EP3 Technical Manual page 23

Note:
Only two screws are necessary to install the option on an HV600 drive.
A - Option
B - Included screw
6.
Use one of the remaining included screws (B) to connect the ground wire (A) to the ground terminal and
installation hole on the option.
Tighten the screw to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 in∙lb to 5.3 in∙lb)
Note:
Wire the ground wire as specified by
A - Ground wire
B - Included screw
YASKAWA SIEP C730600 89E PROFINET Technical Manual
C - Connector CN5
Figure 5.19 Install the Option
Figure 5.20.
C - Crimp terminal
Figure 5.20 Connect the Ground Wire
5 Installation Procedure
23