YASKAWA SI-EP3 Technical Manual page 18

5 Installation Procedure
A - Holder
B - Keypad connector tab
C - Keypad connector
3.
Carefully remove the LED Status Ring board (A) and put it in the temporary placement holes (B) on the
right side of the drive.
Refer to the drive manuals for more information.
NOTICE
board, it can cause incorrect operation and damage to the drive.
A - LED Status Ring board
4.
Insert the option (A) into the CN5-A connector (C) on the drive and use the included screws (B) to put it in
place.
Tighten the screws to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 in∙lb to 5.3 in∙lb)
Note:
1. A ground wire is not necessary. Do not use the ground wire.
2. Only two screws are necessary to install the option on GA700, GA800, CR700, and CH700 drives.
3. Three screws and one ground wire are packaged with option.
18
Figure 5.10 Remove the Front Cover and Keypad
Do not remove the LED Status Ring board cable connector. If you disconnect the LED Status Ring
Figure 5.11 Remove the LED Status Ring Board
D - Drive front cover
E - Keypad
B - Temporary placement holes
YASKAWA SIEP C730600 89E PROFINET Technical Manual